SATO TG308, Service Manual

Page: 114 / 252

Section 4: Operation and Configuration
Page 4-74
TG3 Series Service Manual
4.17 RFID MODE (Cont’d)
RFID MODE
Menu Description
Setting RFID function.
ENABLE
: RFID module is activated.
RFID USER MODE icon will display on the operational menu when
FUNCTION
button is pressed in offline mode.
DISABLE
: RFID function is OFF.
The initial value is DISABLE.
Selecting RFID module type.
TAKAYA
: Setting to TAKAYA module.
HITACHI
: Setting to HITACHI module.
ThingMagic
: Setting to ThingMagic module.
The initial value is TAKAYA.
Notes
:
• If the selected module and the one installed in the printer do not match, the
printer will beep six times when it's turned on, and then RFID function will
be disabled.
• If the RFID module type is changed, the printer saves the selection and
goes to MODULE SELECT COMPLETE screen.
• If the RFID module type is not changed and you just pressed the
FEED
but-
ton, the printer proceeds to the RFID TAG OFFSET screen.
Indicating that RFID module has been changed.
While this message is displayed, the key entry is disabled until power is off.
Setting the RFID tag position from the top of form.
The input range is between 0.79 and 9.45” (20 and 240 mm).
The initial value is 0.79” (20 mm).
Selecting the RFID frequency band.
This screen appears only when the RFID module is set to ThingMagic.
Switch the type of cutter sensors with
/ arrow
buttons.
USA
: Setting to the frequency band for U.S.
EUROPE
: Setting to the frequency band for Europe.
KOREA
: Setting to the frequency band for Korea.
CHINA
: Setting to the frequency band for China.
THAILAND
: Setting to the frequency band for Thailand.
The initial selection is USA.