SATO TG308, Service Manual

Page: 88 / 252

Section 4: Operation and Configuration
Page 4-48
TG3 Series Service Manual
4.12 TEST PRINT MODE
(
Cont’d)
3)
Third piece
-- Setting values in both User Mode and Advanced Mode, sensor information and DSW setting
will be printed.
Item name to be printed Description
Transmissive Sensor
Low [0.2<Lo<1.0] x.x(V)
High [0.8<Hi-Lo] x.x(V)
Slice Level Auto
This information will be printed when transmissive sensor is
enabled.
If “Low” is not [0.2 < Low < 1.0], “Low” will be indicated in reverse
color.
If “High” is [0.8 < (High-Low)], “High” will be indicated in reverse
colors.
Priority Setting The validity of priority setting.
“Command” will be printed when this setting is available. If not,
“Internal” will be printed.
Print Area Print area setting supported in the existing model “XL4xxe”.
“Enabled” will be printed when this setting is available. If not, “Dis-
abled” will be printed.
Stacker/Rewinder The validity of stacker/rewinder status detection. “Enabled” will be
printed when this function is on. If not, “Disabled” will be printed.
Ribbon Nonlock The validity of ribbon nonlock detection.
“Enabled” will be printed when this function is on. If not, “Disabled”
will be printed.
F-Pitch Offset(VR) Pitch offset value for factory default in “mm” scale.
Pitch (VR) Pitch offset value in “mm” scale.
Offset(VR) Offset value for cut position in “mm” scale.
Darkness (VR) Print darkness setting value.
Pitch Offset
Cut Offset
Backfeed Offset
Slice Level Tag/Label stop position, cut position, backfeed distance, and sen-
sor slice level.
[T C] = Center hole tag
[T I] = I-mark tag
[T S] = Side hole tag
[T E] = Edge tag
[L G] = Gap label
[L I] = I-mark label
[N S] = Sensor disabled
Item name to be printed Description
Print Speed Print speed.
Print Darkness Print darkness and range settings.
Print Offset H
Print Offset V Print offset values.