SATO TG308, Service Manual

Page: 241 / 252

Section 8: Appendix
TG3 Series Service Manual
Page 8-11
8.6 OFFSET POSITION ADJUSTMENT (Cont’d)
8.6.4 Adjustment of Media Feeding Position
A feeding error in automatic feeding function or a detection error by the media sensor may cause the incorrect
print position of the first label or tag right when executing automatic feeding function. The loading offset is to
correct the print position right after performing auto media feed.
Note that this adjustment is reflected in the print position right after executing auto media feed only, not for the
print position after paper ejection or normal feeding motion.
The default value and its motion are described below.
Item Default value
Loading offset Tag Center hole +00
Side hole +00
Edge +00
I-Mark +00
Label Gap +00
I-Mark +00
Sensor off +00
Platen roller
(Base reference point)
Discharging roller Feed roller
Misalignment at the top of tag
( + ) direction ( - ) direction
Starts auto paper feed
Feeds the top of tag to the
base reference point
Feeds the tag to the
ejection roller (Detects
whether the tag is wasted
or not)
Backfeed to the base
reference point
Loading offset (Media feeding position adjustment)