Section 7: Replacement Procedures
Page 7-42
TG3 Series Service Manual
7.28 REPLACING OPTIONAL STACKER TIMING BELT (ST-TG3)
1.
Before proceeding, switch off the printer and remove the optional Stacker unit installed at the front of the
printer.
2.
Detach the
Cover (LH)
of the Stacker unit. Refer to
Section 7.27 Replacing Optional Stacker PCB (ST-
TG3)
for details.
To replace the Timing belt (motor) of the stacker
3.
Loosen the two
fixation screws
(1) of the
stacker motor
.
4.
Move the motor mounting position left and right for adjustment and replace the defective
Timing belt
(2)
as necessary.
5.
Adjust the tension of stacker motor timing belt based on
Section 6.21 Adjusting Optional Stacker Motor
Timing Belt Tension (ST-TG3)
.
6.
If you need to replace the
timing belts (media)
, continue the following procedures, otherwise, reverse the
above procedures for reassembly.
To replace the Timing belts (media) of the stacker
7.
Detach the
Cover (RH)
of the
Stacker unit
.
First, remove a tight
screw
to detach the purple
Label/tag latch
. Then, remove four
screws
(3) at the
PCB board side that hold the
Cover (RH)
to the center frame.
8.
Detach the
Label/tag latch assembly
.
First unhook two
springs
(4) on both side of the
Label/tag latch shaft
and then remove the
Label/tag
latch assembly
from the stacker.
9.
Remove three
large screws
(5) and two
screws
(6) on the
side frame
. Release the the
Spring (tension)
(7)
and put aside. Remove the
side frame
as well as the four
Bearing
(8) attached.
2
1
1
Summary of Contents for TG308
Page 1: ...Service Manual For printer model TG3 Series www satoamerica com PN 9001226 A...
Page 6: ...Table of Contents Page iv TG3 Series Service Manual This page is intentionally left blank...
Page 7: ...Section 1 Introduction TG3 Series Service Manual Page 1 1 INTRODUCTION...
Page 251: ...Section 9 Sato Group of Companies TG3 Series Service Manual Page 9 1 SATO GROUP OF COMPANIES...
