Section 6: Checks and Adjustment Procedures
Page 6-46
TG3 Series Service Manual
6.22 ADJUSTING OPTIONAL STACKER TIMING BELT TENSION (ST-TG3)
Required tool:
Phillips head screwdriver
Measurement
:
1.
Detach the
Cover (LH)
by removing the five screws.
2.
Access and remove the four
screws
that hold the
Cover (RH)
to the
center frame
.
3.
Turn the printer around to access the front of the stacker.
4.
Remove the screw that secures the purple label/tag latch. Remove the latch. Slide toward you the lower
front panel.
5.
Move the pressure shaft of the three media feeding belts up and down for adjustment. Make sure the three
belts have the same belt tension.
6.
If the timing belt cannot be adjusted by this procedure, replace the timing belt based on the procedure, in
the
Section 7.28 Replacing Optional Stacker Timing Belt (ST-TG3)
of this manual.
[IMPORTANT] Make sure three belts have the same tension.
Loosen the screw
Pressure shaft
Pressure shaft
Loosen the screw
Summary of Contents for TG308
Page 1: ...Service Manual For printer model TG3 Series www satoamerica com PN 9001226 A...
Page 6: ...Table of Contents Page iv TG3 Series Service Manual This page is intentionally left blank...
Page 7: ...Section 1 Introduction TG3 Series Service Manual Page 1 1 INTRODUCTION...
Page 251: ...Section 9 Sato Group of Companies TG3 Series Service Manual Page 9 1 SATO GROUP OF COMPANIES...
