Section 4: Operation and Configuration
TG3 Series Service Manual
Page 4-59
4.14 MAINTENANCE MODE
In Maintenance mode, you can further access Service mode, Factory mode and RFID mode for more printer
configuration.
1.
Make sure the Power of the printer is turned off (O).
2.
While pressing the
and
arrow
buttons simultaneously, switch the Power to On ( I ).
The printer enters MAINTENANCE mode.
Note:
You may also access MAINTENANCE mode by pressing the
FUNCTION
button,
and
arrow
buttons
simultaneously, switch the Power to On ( I ).
3.
Press
/ arrow
buttons to select SERVICE MODE, FACTORY MODE, or RFID MODE, and then press
FEED
button to enter the selected mode.
Press FU + button
+ Switch Power to On “ I ”
or
Press + button
+ Switch Power to On “ I ”
* Press , , or button to select
item accordingly. The active arrow
icons are displayed on the screen.
Service Mode
RFID Mode
Select SERVICE
MODE +
FEED button
Select RFID
MODE +
FEED button
Factory Mode
Select FACTORY
MODE +
FEED button
Summary of Contents for TG308
Page 1: ...Service Manual For printer model TG3 Series www satoamerica com PN 9001226 A...
Page 6: ...Table of Contents Page iv TG3 Series Service Manual This page is intentionally left blank...
Page 7: ...Section 1 Introduction TG3 Series Service Manual Page 1 1 INTRODUCTION...
Page 251: ...Section 9 Sato Group of Companies TG3 Series Service Manual Page 9 1 SATO GROUP OF COMPANIES...
