Rohde & Schwarz 1065.6000.20, Operating Manual

Page: 58 / 438

FSE Notation
1065.6016.12 6.1 E-16
6 Description of Commands
Notation
In the following sections, all commands implemented in the instrument are first listed in tables and then
described in detail, separated according to the command system. The notation corresponds to the one
of the SCPI standards to a large extent. The SCPI conformity information can be taken from the
individual description of the commands.
Table of Commands
Command: In the command column, the table provides an overview of the commands
and their hierarchical arrangement (see indentations).
Parameter: The parameter column indicates the requested parameters together with
their specified range.
Unit: The unit column indicates the basic unit of the physical parameters.
Remark: In the remark column an indication is made on:
– whether the command does not have a query form,
– whether the command has only one query form
– whether this command is implemented only with a certain option of the
instrument
Indentations The different levels of the SCPI command hierarchy are represented in the
table by means of indentations to the right. The lower the level is, the
farther the indentation to the right is. Please observe that the complete
notation of the command always includes the higher levels as well.
Example:
:SENSe:FREQuency:CENTer
is represented in the table as
follows:
:SENSe
first level
:FREQuency
second level
:CENTer
third level
Individual description In the individual description, the complete notation of the command is
given. An example for each command, the *RST value and the SCPI
information is written out at the end of the individual description.
The modes for which a command can be used are indicated by the
following abbreviations:
A Spectrum analysis
A-F Spectrum analysis - frequency domain only
A-Z Spectrum analysis - time domain only (zero span)
VA Vector signal analysis (option FSE-B7)
VA-D Vector signal analysis - digital demodulation (option FSE-B7)
VA-A Vector signal analysis - analog demodulation (option FSE-B7)
BTS GSM BTS analysis (option FSE-K11)
MS GSM MS analysis (option FSE-K10)
Note: The spectrum analysis (analyzer) mode is implemented in the
basic unit. For the other modes, the corresponding options are
required.