Rohde & Schwarz 1065.6000.20, Operating Manual

Page: 111 / 438

CALCulate Subsystem FSE
1065.6016.12 6.54 E-16
:CALCulate<1|2>:MARKer<1 to 4>:FUNCtion:SUMMary:PPEak[:STATe] ON | OFF
This command switches on or off the measurement of the positive peak value if the calculation and.
Example:
":CALC:MARK:FUNC:SUMM:PPE ON"
Features: *RST value: OFF
SCPI: device-specific
Mode: VA
When the measurement is switched on, the summary marker is automatically activated (command
SUMMary:STATe
set to
ON
). When it is switched off, the summary marker remains switched on
provided further measurements are selected. Otherwise the marker is switched off automatically.
:CALCulate<1|2>:MARKer<1 to 4>:FUNCtion:SUMMary:PPEak:RESult?
This command is used to query the result of the measurement of the positive peak value. Results of
average calculation and peak hold are queried with commands
...:PPEak:AVERage:RESult?
and
...:PPEak:PHOLd:RESult?
.
Example:
":CALC:MARK:FUNC:SUMM:PPE:RES?"
Features: *RST value: -
SCPI: device-specific
Mode: VA
This command is only a query and thus has no *RST value assigned.
:CALCulate<1|2>:MARKer<1 to 4>:FUNCtion:SUMMary:PPEak:AVERage:RESult?
This command is used to query the result of the measurement of the positive peak value if the
average is calculated using the command
:CALCulate<1|2>:MARKer<1 to 4>:FUNCtion:
SUMMary:AVERage.
Example:
":CALC:MARK:FUNC:SUMM:PPE:AVER:RES?"
Features: *RST value: -
SCPI: device-specific
Mode: VA
This command is only a query and thus has no *RST value assigned.
:CALCulate<1|2>:MARKer<1 to 4>:FUNCtion:SUMMary:PPEak:PHOLd:RESult?
This command is used to query the result of the measurement of the positive peak value if the peak
hold function is switched on with command
:CALCulate<1|2>:MARKer<1 to 4>:FUNCtion:
SUMMary:PHOLd
.
Example:
":CALC:MARK:FUNC:SUMM:PPE:PHOL:RES?"
Features: *RST value: -
SCPI: device-specific
Mode: VA
This command is only a query and thus has no *RST value assigned.