Rohde & Schwarz 1065.6000.20, Operating Manual

Page: 104 / 438

FSE CALCulate Subsystem
1065.6016.12 6.47 E-16
:CALCulate<1|2>:MARKer<1 to 4>:FUNCtion:SFACtor:FREQuency?
This command queries the frequencies of the shape factor measurement.
Example:
":CALC:MARK:FUNC:SFAC:FREQ?"
Features: *RST value: -
SCPI: device-specific
Modes: A, BTS, MS
Four frequency values (at -60 dB, -6 or. -3 dB, -6 or -3 dB, -60dB) are indicated in ascending order.
They are separated by a comma. This command is only a query which is why it is not assigned an
*RST value.
:CALCulate<1|2>:MARKer<1 to 4>:FUNCtion:STRack[:STATe] ON | OFF
This command switches the signal-track function on or off.
Example:
":CALC:MARK:FUNC:STR ON"
Features: *RST value: OFF
SCPI: device-specific
Mode: A-F
With SIGNAL TRACK function activated, the maximum signal is determined after each frequency
sweep and the center frequency of this signal is set. With drifting signals the center frequency follows
the signal.
:CALCulate<1|2>:MARKer<1 to 4>:FUNCtion:ADEMod:AM[:RESult]? PPEak| MPEak| MIDDle| RMS
This command queries the results of the AM modulation measurement of the analog demodulation.
Example:
":CALC:MARK:FUNC:ADEM:AM? PPE"
Features: *RST value: -
SCPI: device-specific
Mode: VA-A
PPEak Result of the measurement with dePK
MPEak Result of the measurement with detector -PK
MIDDle Result of averaging
±
PK/2
RMS Result of the measurement with detector RMS
In the modulation modes FM or PM query of the MIDDle-result is possible only. This command is
only a query which is why it is not assigned an *RST value.