Rohde & Schwarz 1065.6000.20, Operating Manual

Page: 130 / 438

FSE CONFigure-Subsystem
1065.6016.12 6.73 E-16
CONFigure:BURSt Subsystem
This subsystem provides the commands for configuring the measurements in the GSM BTS Analyzer
mode (option FSE-K11) or GSM MS Analyzer mode (option FSE-K10) which are performed on individual
bursts. (carrier power, phase/frequency error, power vs. time).
COMMAND PARAMETERS UNIT COMMENT
CONFigure
:BURSt
:PFERror
[:IMMediate]
:COUNt
:CONDition
:MACCuracy
[:IMMediate]
:COUNt
:CONDition
:POWer
[:IMMediate]
:COUNt
:CONDition
:PTEMplate
[:IMMediate]
:COUNt
:SELect
:REFerence
:AUTO
--
<numeric_value>
NORMal | EXTReme
--
<numeric_value>
NORMal | EXTReme
--
<numeric_value>
NORMal | EXTReme
--
<numeric_value>
FULL | TOP | RISing | FALLing
<Boolean>
--
--
--
--
--
--
--
--
no query, Option FSE-K11 or FSE-K10 &
FSE-B7
Option FSE-K11 or FSE-K10
Option FSE-K11 or FSE-K10
no query
Option FSE-K11 or FSE-K10 & FSE-B7
No query
Option FSE-K11 or FSE-K10
no query
Option FSE-K11 or FSE-K10
no query
:CONFigure:BURSt:PFERror[:IMMediate]
This command selects measurement of the phase and frequency error of the base station or mobile.
Example:
":CONF:BURS:PFER"
Features: *RST value: --
SCPI: device-specific
Modes: BTS, MS
This command is an event and thus has no query and no *RST value assigned.
It is available only in conjunction with option GSM BTS Analyzer FSE-K11 or option GSM MS
Analyzer, FSE-K10, and Vector Signal Analysis, FSE-B7.
:CONFigure:BURSt:PFERror:COUNt 1 to 1000
This command sets the number of bursts used for the determination of average and maximum value.
Example:
":CONF:BURS:PFER:COUN 100"
Features: *RST value: 500 (GSM/DCS1800 Phase I)
200 otherwise
SCPI: device-specific
Modes: BTS, MS
It is available only in conjunction with option GSM BTS Analyzer FSE-K11 or option GSM MS
Analyzer, FSE-K10, and Vector Signal Analysis, FSE-B7.