Rohde & Schwarz 1065.6000.20, Operating Manual

Page: 288 / 438

FSE SYSTem Subsystem
1065.6016.12 6.231 E-16
:SYSTem:SET <block>
The query
:SYSTem:SET?
causes the data of the current instrument setting to be transmitted to the
controller in binary form (SAVE function). The data can be read back into the instrument (RECALL
function) by means of command
:SYSTem:SET
<block>. If the data records are stored on the
instrument harddisk with SAVE/RECALL (
:MMEMory:STORe
bzw.
:MMEMory:LOAD)
, it is possible
to store the data in an external computer by means of
:SYSTem:SET
.
Example:
":SYST:SET "
Features: *RST value: –
SCPI: conforming
Modes: A, VA, BTS, MS
The receive terminator has to be set to EOI to ensure reliable transfer of data (setting
SYST:COMM:GPIB:RTER EOI
).
:SYSTem:PRESet
This command triggers an instrument reset.
Example:
":SYST:PRES"
Features: *RST value: –
SCPI: conforming
Modes: A, VA, BTS, MS
The effect of this command corresponds to that of the PRESET key with manual control or to the
*RST command.
:SYSTem:SPEaker<1|2>:VOLume 0 to 1
This command sets the volume of the built-in loudspeaker for demodulated signals. The numeric
suffix selects the measurement window.
Example:
":SYST:SPE:VOL 0.5"
Features: *RST value: 0
SCPI: device-specific
Modes: A
The value 0 is the lowest volume, the value 1 is the highest volume.
:SYSTem:TIME 0 to 23, 0 to 59, 0 to 59
This command sets the internal clock.
Example:
":SYST:TIME 12,30,30"
Features: *RST value: –
SCPI: conforming
Modes: A, VA, BTS, MS
The sequence of entry is hour, minute, second.