Porsche 996 TT, Repair Manual

Page: 1828 / 2099

96 64 32 Converting installation position for tilt
sensor, additional alarm system M536
Note
Tools
Note
As from model year 2002, the tilt sensor will be installed under the left front seat next to the alarm
control module. •
In vehicles up to model year 2001 inclusive, the tilt sensor is located in the radiator tank to the right of
the battery. •
If a new tilt sensor must be replaced in vehicles produced before model year 2002, the conversion
prcedure described below must be carried out.
•
In connection with the the parking assistant control module, a new bracket (from model year 2002), a
new tilt sensor, a bracket for the tilt sensor and a wiring harness will be required for the conversion. •
Disconnect battery ’ 9 Work instructions after disconnecting the battery. •
Use the wiring diagram for the central locking alarm system, sheet 8 / 8A. •
1. Remove the battery cover and the right cowl panel cover.
2. Pull off the plug on the tilt sensor.
3. Unscrew the fastening nut −arrow− .
4. Remove the tilt sensor and tie the electrical lead with insulating
tape.
5. Fit the battery cover and the right cowl panel
cover.
96 64 32 Converting installation position for tilt sensor, additional alarm system M536 1765