Porsche 996 TT, Repair Manual

Page: 1829 / 2099

6. Remove the left front seat ’ 720119 Removing and installing front seat, Group 7, Chapter 72−1 .
7. If a control module with parking assistant is installed, remove the bracket. To do so, unscrew the
two fastening screws −arrow− and disconnect both plugs. => Removing and installing control
module for parking assistant
8. Remove the alarm system control module. => Removing and installing control unit for alarm system
9. Disconnect the plug of the alarm control module, open the plug −A− and pull out the pin strip
−B− .
10. Remove pins 38 and 11 with the press−out tool 90207, insulate the lead and tie it to the wiring harness.
=> Tools
11. Push the pin of the grey lead from the service set into the plug for pin 38 until it engages and push
the pin of the grey/black lead into the plug for pin 11 until it, too, engages. => Tools
12. Push the pin strip −B− into the plug sleeve −A− and lock the plug.
einordnung
96 64 32 Converting installation position for tilt sensor, additional alarm system M536 1766