Porsche 996 TT, Repair Manual

Page: 1042 / 2099

order to avoid paint damage.
During emergency release, the spoiler must be held tightly by an assistant.
•
No. Procedure Instructions
1 Extend spoiler −1−
(with drive module
intact) Extend spoiler manually using the rocker switch with the ignition
switched on.
2 Lift up spoiler −1− (if
drive module is faulty) Pull spoiler upwards and push in two support pads −2− approx. 60 mm
high on the right and left between the rear lid and the spoiler. Note:
use suitable packaging material (e.g. styropore pad, cardboard) as a
support pad. The support pads should only be pushed in to the positions
shown in the figure.
3 Position outer tubes of
the extension elements Align the bore on the outer tube of the extension element −arrow− with
the bore of the closure peg −4− by turning the outer tube −3− .
The outer tube should be turned in an anti−clockwise direction only.
4 Unlock right extension
element Insert hook wrench ’ No. 80/1, 2.4 Workshop Manual into the bores and
turn clockwise by 90°.
5 Unlock left extension
element Insert hook wrench ’ No. 80/1, 2.4 Workshop Manual into the bores and
turn clockwise by 90°.
Remove spoiler −1− Lift the spoiler up and off.
top of page
Installing rear spoiler
einordnung
Installing rear spoiler 979