Porsche 996 TT, Repair Manual

Page: 2065 / 2099

pulling the plug connection apart.
4. Lay the 6−pin plug under the right cowl panel cover and connect the plug to the 6−pin plug located under
the right dome strut. Fasten the plug connection to the wiring harness with a tie wrap.
5. Unscrew the hexagon−head bolt M 6 x 12 on the positive cable −2− at the positive battery terminal.
6. Remove the ground cable −1− from the relay (terminal 88) (in left−hand drive vehicles laid next to the
battery). In right−hand drive vehicles, make sure that the battery is installed in the opposite manner from
that shown in the illustration.
7. Unscrew the ground cable from the relay (terminal 88a) to the bulkhead/body ground point and remove.
8. Screw the battery ground cable fitted upon delivery to the bulkhead/body (tightening torque 20 Nm (15
ftlb.)).
9. Unscrew the hexagon−head bolt M 8 x 16 designed for fastening the main battery relay holder and remove
the main battery relay including holder, wiring and hexagon−head bolt from the vehicle.
10. Connect the battery ground cable to the ground terminal of the battery and tighten the hexagon−head bolt
with a tightening torque of 6 Nm (4.5 ftlb.).
11. Fit the cowl panel cover and the battery cover.
top of page
Removing the inner EMERGENCY STOP switch
The necessary EMERGENCY STOP switch is installed depending on the additional equipment present:
einordnung
Removing the inner EMERGENCY STOP switch 2002