Porsche 996 TT, Repair Manual

Page: 1021 / 2099

4 Install
ParkAssistent
sensor −7−
(only version with
ParkAssistent!) Engage installation housing −9− . Engage ParkAssistent sensor −7− with
isolating ring −8− .
’ 917519 Removing and installing sensor for ParkAssistent
5 Install lower
retaining strip −5− Push up lower retaining strip −5− and fasten with rivets −6− .
6 Install shield
cover −2− Insert shield −3− and shield cover −2− with rivet bolts −1− . Press on new
clamping washers −3− .
Note:
make sure that the system is free of gaps.
Install rear spoiler => Install rear spoiler
top of page
Additional instructions for replacing the rear spoiler
Note
Additional cut−outs must be made for the impact horns (USA version) in the rear spoiler before the
new component is painted. •
For the ParkAssistent equipment version, no additional bore must be made on the new component. A
special spare part is available for this version which contains the bores and retainer plates to hold the
ParkAssistent. •
1. Drill hole −C− in accordance with the markings inside the rear spoiler.
2. Saw out cut−outs −B− in accordance with the markings inside the rear spoiler.
3. Slant the upper and lower cut edges of the cut−outs −B− at an angle of −40°− (see cut −A−A− ).
einordnung
Additional instructions for replacing the rear spoiler 958