Porsche 996 TT, Repair Manual

Page: 1270 / 2099

4. Turn over the control module holder −3− and push it in under the fastening nut −2− . Tighten both
fastening screws −1− and the fastening nut −2− . Tightening torque: 10 Nm (7.5 ftlb.).
5. Place carpet lining in position, paying attention to the fitted
shape.
6. Program the DME control module with the Porsche System Tester. => Programming the new DME
control module 911 Turbo (996) => Programming the new DME control module − GT2 and version X51
=> Programming the DME control module 911 Turbo (996) => Programming DME control module −
GT2 and version X51
top of page
Programming the new DME control module 911 Turbo (996)
Note
If a new DME control module is to be installed in a vehicle, the DME code specified in IPAS and the
immobilizer code must be entered in the DME control module.
•
You can get the codes from IPAS or from your importer by specifying the vehicle identification
number. •
During DME programming, it is essential to guarantee the power supply for the Porsche System
Tester. In case of doubt, connect a charging unit to the vehicle battery. •
Symbol for the TAB key = ’| . •
Follow the instructions for the Porsche System Tester. •
1. Connect the Porsche System Tester to the vehicle and start the System Tester. Switch ignition on.
2. Select vehicle type using the cursor keys. In the 911 Turbo − 911 (996).
3. Using the ’| key, move from the vehicle type to the list of control units.
4. Select DME with the cursor keys and press the >> key.
5. Select "Control unit programming" with the cursor keys and press the >> key.
6. Select "Control unit programming with the cursor keys and press the >> key. Follow the
displayed programming instructions from the Porsche System Tester.
7. Enter the Veh. Ident. No. with the cursor keys, continue with >> and confirm with F7.
8. Enter the new DME (IPAS) programming code and confirm with the >> key.
9. Check the DME programming code again; if the code is correct, confirm with the F7 key.
10.
einordnung
Installing the DME control module 1207