Porsche 996 TT, Repair Manual

Page: 781 / 2099

through the body opening.
12. Press the shift and selector cables downward through the body opening. To do this, carefully press
the support bracket sleeves through the body opening and pull the B+ wire out of the slotted rubber
sleeve.
Installing shift and selector cables
Note
Each time the shift cables are removed from the transmission lever, the retaining clips of the shift
cable end pieces must be replaced. •
1. Apply a generous coating of lubricant (e.g. Contifix tyre mounting paste) on the rubber sleeve and B+
wire in the area of the body opening.
2. Push shift and selector cables −C− through the body opening from
behind.
3. Insert B+ wire −A− into the slot of the rubber sleeve −B− and press sleeve into the body
opening.
4. Clip support bracket sleeves into the support bracket.
5. Fasten shift cable end pieces on the shift
lever.
6. Install transmission
support.
Tightening torque: 65 Nm (48 ftlb.)
7. Fit underbody panels (middle and rear).
8. Bend tabs in the vehicle interior downward so that the rubber sleeve can no longer slip out of
place.
9. Install parking brake console.
Tightening torque: 23 Nm (17 ftlb.)
10. Check function of parking brake and adjust it if necessary.’ 46 83 16 Adjusting parking brake shoes.
Note
The shift and selector cables are routed underneath the console. •
einordnung
Installing shift and selector cables 718