Porsche 996 TT, Repair Manual

Page: 915 / 2099

No. Designation Qty. Removal Installation
1 Plastic
body−bound rivet
5.0 x 11.5 1 Press out pin in the centre
of the rivet head.
2 Rubber sleeve 1 Pull off. Press in.
3 Guide ring 1 Press lug −A− and
disengage.
4 Tank lock 1
5 Sleeve 1 Press lugs of the sleeve
−B−
and disengage.
6 Collar nut
M6 x 20 1 Tightening torque: −10 Nm (7.5 ftlb.)−
7 Angle piece 1
8 Plastic clip 1 Press apart lugs −C− and
pull off.
9 Collar screw
M6 x 20 2 Undo two turns.
10 Collar nut
M6
2
11 Wing brace 1
12 Torx sheetmetal
screw
T 20
13 Protective film 1 Replace
14 Sheetmetal screw
St 6.3 x 12
4
15 Sheetmetal nut 11
16 Wing 1 Pull out downwards at the
A−pillar and remove to the
front. Insert the wing under the lid hinge at the
front, fit the sheetmetal screws. Adjust
contours and joining dimensions
(see: Serv. No. 5 Diagram, Body joining
plan)
to the door and covers, tighten sheetmetal
screws −14, 12− .
17 Sheetmetal nut
−17−
2
18 Retaining strip 1 Undo the collar nuts−10−
out of the restraining strip. Fix retaining strip on the wing upward to the
stop and fasten with the collar nuts −10− .
Tightening torque:−10 Nm (7.5 ftlb.)−
19 Transparent
protective film
1 Pull off. Replace.
20 Electrical plug
connection −20−
1 Press lug and separate.
21 Emergency cable 1
einordnung
50 55 19 Removing and installing the wing 852