Porsche 996 TT, Repair Manual

Page: 1291 / 2099

5. Heat bearing inner race (no. 13 in overview) to 120°C and push onto input shaft.
6. Push 4th gear loose gearwheel (no. 12 and 10 in overview) and thrust plate (no. 9 in overview) onto
input shaft. The large flat−ground side of the thrust plate faces towards the loose gearwheel (4th
gear).
7. Heat bearing inner race (no. 6 in overview) to 120°C and push onto input shaft.
8. Fit clamping plate with short lock (no. 5 and 8 in overview), four−point bearing (no. 4 in overview)
and shift fork (no. 7 in overview) onto input shaft.
9. Heat bearing inner race (no. 3 in overview) to 120°C and push onto input shaft.
10. Heat cylindrical−roller bearing (no. 2 in overview) to 120°C and push onto input shaft.
11. Screw new hexagon nut onto input shaft.
Tightening torque: 250 Nm (185 ftlb.)
Tightening torques
Location Thread Tightening torque Nm (ftlb.)
Hexagon nut M30 x 1.5 250
top of page
Installing input and output shaft
Installing shafts
Note
An overview diagram of the installation is provided in the chapter Disassembling transmission under
=> Overview. •
1. Insert output shaft −A− with adjusting shim S5 −B− and adusting shim S4 −C− into tensioning plate −F−
.
2. Push 4th gear fixed wheel −D− onto output shaft. The large collar faces the tensioning plate.
3. Push on the spacer sleeve −E− .
einordnung
Assembling shafts 1228