Porsche 996 TT, Repair Manual

Page: 712 / 2099

13. Pull off the hose clamp −arrow− on the coolant connecting hose. Take bracket for the generator
out of the engine compartment upward and to the right.
14. Separate bracket for the generator. The bracket can be disassembled in the event of leaks. Unscrew the
three screws −arrows− for this purpose. Pull the two parts apart. Make sure that the two dowel sleeves
are not lost. Use a new O−ring with Vaseline when assembling the bracket for the generator.
Tightening torque of the three screws: 23 Nm (17 ftlb.)
top of page
Installing bracket for generator
1. Install bracket for the generator. Replace the four O−rings on the connecting sleeves between the two
coolant outlet necks and the bracket for the generator. Insert the bracket into the coolant outlet neck of
cylinder bank 1 to 3 from the right−hand side. Then screw in the four fastening screws.
Tightening torque: 65 Nm (48 ftlb.)
Note
Insert the front right screw −inset− with Loctite 574. •
einordnung
Installing bracket for generator 649