Porsche 996 TT, Repair Manual

Page: 1448 / 2099

No. Procedure Instructions
1 Preparing spare part Remove the factory−applied primer on the welding areas of the spare part
−A, B, C, D− using the rotary brush.
2 Cleaning the
welding areas Remove underbody coating and paint layers, etc. from the welding areas of
the body with a hot−air gun or rotary brush.
3 Fitting the outer
roof panel Insert outer roof panel into the body.
Measure the dimension −X = 25.2 mm− on the left and right of the roof
channel.
It is necessary to measure dimension X between four corner points on the
outer roof panel and the outer side section.
4 Installing roof joint
strips As a check, install the roof joint strips on the left and right.
’ 663619 Removing and installing roof joint strip.
If necessary, recenter outer roof panel.
einordnung
Preparation of roof for installation and fitting 1385