Porsche 996 TT, Repair Manual

Page: 1798 / 2099

Installing the car radio
1. Before the new radio is installed, unlock and disconnect the protective plug −A− for the optical
waveguide.
2. Press in electrical plug and optical waveguide plug on car radio until the plugs are felt to engage −a− .
Note
Before sliding the car radio into the installation slot, make sure that the electrical leads are not trapped
by the car radio or damaged. •
3. Push the car radio into the installation slot until the locks engage on the radio
housing.
top of page
Teaching the car radio
Note
If a new car radio is to be installed in a vehicle, the PCM2/CDR23 code specified in IPAS must be
used. •
You can get the codes from IPAS or from your importer by specifying the vehicle identification
number. •
If possible, before the car radio is removed and replaced, a read−out of the vehicle data should be
obtained and noted down using the Porsche System Tester. •
During coding, the power supply for the Porsche System Tester should be guaranteed. Connect a
battery charging device to the vehicle battery. •
einordnung
Installing the car radio 1735