Porsche 996 TT, Repair Manual

Page: 620 / 2099

16. Tighten hexagon−head bolt M6 x 12 of the filler neck −arrow− . Coat seat of the cap seal with Vaseline.
Tightening torque 10 Nm (7.5 ftlb.)
17. Fill and bleed cooling system ’ 19 38 17 Filling and bleeding the cooling system .
18. Refill fuel tank.
19. Calibrate fuel level sensor system => Calibrating fuel level sensor system.
20. Install front wheel housing liners ’ 50 56 19 Removing and installing front wheel housing liner .
Note
Observe specification for greasing wheel bolts ’ 44 05 19 Removing and installing wheel . •
21. Fit the front wheels, using the prescribed special tool socket wrench insert P 300 to avoid damage to
the wheels.
Tightening torque of the wheel bolts : 130 Nm (96 ftlb.).
22. Connect the battery ’ 9 Work instructions after disconnecting the battery .
23. Remove steering wheel holder.
24. Check wheel arch values. In the case of deviations, perform a suspension alignment if necesary and
adjust ’ 44 Wheels, tires, suspension alignment .
Tightening torques for front axle and fuel tank
Location Thread
Tightening torque Nm
(ftlb.)
Cross member/side member on body (front and rear) M14 x 1.5 160
Corner plate on body M12 x 1.5 100
Diagonal brace on body and side member M12 x 1.5 100
Front−axle drive shaft to final drive M8 39
Rear front−axle transmission support to body M10 65
Front front−axle transmission support to front−axle cross
member M10 65
Stud to front−axle cross member M8 20
Tank strap to body M8 23
Stabilizer mount to stabilizer M10 46
Universal joint (steering shaft) to steering gear M8 23
Steering gear to cross member M10 x 1.5 65
einordnung
Tightening torques for front axle and fuel tank 557