Porsche 996 TT, Repair Manual

Page: 1550 / 2099

± 10 mm− . The contact pressure on the rear window inner seal or the offset
from the door window is adjusted by screwing both of the upper adjusting
elements −B− in or out by dimension −X = ± 5 mm− .
Adjustment tool for the rear power window.
=> Tools and materials Step 1: −Figure 3−
Adjust the basic setting of the adjusting elements −B− from the top edge of
the rear side section to the side window.
−Dimension C−
Front top edge of rear side section = 11 mm
−Dimension D− Rear top edge of rear side section = 14 mm
Step 2: −Figure 3−
Push the power window backward or forward to adjust the −gap E = 9 mm−
between the side window and door window.
Step 3: −Figure 4−
Adjust the contour or the offset from the door window on adjusting element
−A−
. Screw down adjusting elements −A− and −B− .
Tightening torque 23 Nm (17 ftlb.)
4 Installing rear side
window inner seal Insert rear side window inner seal −3− into rear side section slot and position
on the convertible−top support or belt guide section.
Screw in fastening screws −2− and tighten.
5 Installing
side−panel lining ’ 70 75 19
top of page
Additional instructions for adjusting or replacing the rear power
window
1. The rear power windows can be operated if:
the convertible−top is closed. •
the ignition is switched on. •
after the ignition is switched off, if the ignition key is not removed from the steering lock. •
after the ignition is switched off until a door is opened for the first time.
•
the door is open, USA vehicles do not have this function. •
1. Standardising the system
The system must be re−standardised after an interruption in the power supply to the power window
electronics. To do this the convertible top must be closed. The position−controlled lowering function in the
case of convertible top actuation, and enabling for "automatic start−up" of window closing and opening are
redefined. The standardisation process is initiated by continuous actuation of the operating button toward
"close window". To do this the convertible top must be closed and the hardtop must be fitted. The button must
be held until the window is closed and is switched off by the blockage detection function of the power
windows.
2. Blockage detection function
If the window drive encounters resistance when activated, the motor is switched off after a delay of 500 ms. If
the rocker switch is pressed again within 10 seconds, the side window closes the power window with all of its
closing force. The anti−crushing protection is deactivated.
top of page
einordnung
Additional instructions for adjusting or replacing the rear power window 1487