Porsche 996 TT, Repair Manual

Page: 1929 / 2099

2 Shaft seal 1 Install only after fitting the gear set.
3 Shaft seal 1 Drive in shaft seal with pressure piece
VW 513 as far as the mounting face. Fill
the space between the dust and sealing
lips with grease (e.g. Liqui Moly).
4 Ball sleeve 4 Remove with special tool striker
VW 771 , special tool threaded
part VW 771/15 and a suitable
internal puller. Drive in with special tool pressure piece
9648 . (Installation depth 0.6 mm).
5 Outer bearing
race 1 Drive out with aluminium or
copper mandrel, changing sides. Drive in with special tool pressure piece
3062 and special tool mandrel VW 295
as far as the mounting face.
6 Outer bearing
race 1 Drive out from the inside with
special tool pressure piece VW
513 . Drive in with special tool pressure pieces
9247 and special tool pull−in tool and
extractor P 254 .
7 Outer bearing
race 1 Drive out from the inside with
special tool drift P 264 b . Drive in with special tool pressure piece
P 254 b and special tool pull−in tool and
extractor P 254 .
8 Circlip 1 Fit in correct position and make sure it is
seated properly.
9 Selector lever 1 Use special tool protective sleeve 9649 .
Insert in the correct position.
10 Rubber washer 1
11 Selector lever 1
12 Shaft seal 1 Drive in with special tool pressure piece
9649/1 . Fill the space between the dust
and sealing lips with grease (e.g. Liqui
Moly).
13 Bushing 2 Drive out with special tool
pressure piece 9648/2 . Drive in with special tool pressure piece
9648/1 .
14 Shift pinion 1 Axial play 0 to 0.15 mm. Setting with
shim (No.15).
15 Adjusting shim X Mark for refitting. Remeasure if necessary.
16 Snap ring 1 Push the snap ring and cap (no. 17)
down until the snap ring engages into the
groove.
17 Closure cap 1
18 Compression
spring
1
19 Bearing screw* 1 Remove with special tool socket
wrench insert 9658 .
Unscrew it only if the
transmission has to be
disassembled! •
Tighten to 50 Nm (37 ftlb.).
20 Swivel arm 1
einordnung
Overview 1866