MAC215990
406
Revision A
Cam end bushings
1004616
A
B
Figure 4.307: Cam End
2.
Position bushing halves (B) on tine tube (A) with the
flangeless end adjacent to the tine tube arm, and position
the lug in each bushing half into the hole in the tine tube.
3.
Slide tine tube (A) towards the tail end of the reel to insert
bushing (B) into the tine tube arm. If the tine tube supports
are installed, ensure that the bushings at those locations
slide into the support.
4.
Reinstall the previously removed fingers. Refer to the
following procedures as needed:
•
Removing Plastic Fingers, page 398
•
Removing Steel Fingers, page 396
1001245
A
B
Figure 4.308: Bushing
5.
Install bushing clamp (A) onto the tine tube adjacent to the
flangeless end of bushing (B).
6.
Position clamp (A) on bushing (B) so the edges of the clamp
and bushing are flush when the clamp is fit into the groove
on the bushing and the lock tabs are engaged.
1009869
A
B
Figure 4.309: Installing Clamp
7.
Tighten clamp (A) using modified channel lock pliers (B)
until finger pressure will
NOT
move the clamp.
IMPORTANT:
Overtightening the clamp may result in breakage.
