MAC215990
417
Revision A
1032032
A
B
Figure 4.335: Reel Endshield Removed
–
Outboard
Tail End
7.
Remove the reel endshield from supports (A).
8.
Remove the reel paddle, if it is installed on the reel
endshield.
NOTE:
Reel end paddles (B) are installed alternately on the reel
endshields.
1032034
A
D
B
C
E
Figure 4.336: Reel Endshields
–
Outboard Tail End
9.
Slightly lift the end of reel endshield (A) off of support (B).
10. Position new reel endshield (C) onto support (B) under
existing reel endshield (A).
11. Position the other end of new reel endshield (C) on other
support (E) over the existing reel endshield.
12. Reinstall three bolts (D).
13. Reinstall the paddle (removed in Step
) onto the
new reel endshield if previously installed.
14. Tighten all of the installed hardware.
Replacing Reel Endshields at Inboard Tail End
The reel endshields need to be replaced if they are damaged.
DANGER
To prevent injury or death from the unexpected start-up of the machine, always stop the engine and remove the key
from the ignition before leaving the operator
’
s seat for any reason.
NOTE:
Retain all removed parts, unless directed to do otherwise.
1.
Lower the reel fully.
2.
Lower the header fully.
3.
Shut down the engine, and remove the key from the ignition.
