MAC215990
442
Revision A
1032603
A
A
A
B
C
Figure 4.390: Vertical Knife
–
Guard Removed
8.
Remove three bolts (A) securing milling bar (B) to the blade
bracket and knife section assembly (C). Tilt milling bar (B)
upward. Slide assembly (C) out.
D
F
D
G
A
B
H
1032606
A
C
E
C
Figure 4.391: Vertical Knife
–
Guard Removed
NOTE:
If you cannot tilt milling bar (A) upwards enough to slide
knife section assembly (B) out, remove two bolts (C)
securing hood (D) to the vertical knife assembly. Loosen
two nuts (E) to loosen slide rail (F). Milling bar (A) should
now be loose enough to tilt upward.
IMPORTANT:
You should not need to loosen clip hardware (G) and
clips (H) to slide the knife section assembly out. If you need
to loosen this hardware, follow Step
to
properly tighten the hardware when it is reinstalled.
Overtightening this hardware can cause the motor to
overheat, melt plastic components, or burn out.
Undertightening the hardware can cause debris to plug
the knives.
