MAC215990
162
Revision A
1029250
A B
C
D
Figure 3.191: Crop Divider with Latch
12. Engage latch (A) onto crop divider bolt (B).
13. Rotate hex shaft (D) on latch (A) counter-clockwise to
engage lock.
NOTE:
Hex shaft (D) requires a torque of 40
–
54 Nm (30
–
40 lbf·ft)
to close the latch. If adjustment is required, loosen latch (A)
and adjust bolt (B) to correct the amount of torque
required.
14. Secure with lynch pin (C).
15. Close the endshield. For instructions, refer to
Removing Floating Crop Dividers
Floating crop dividers can be removed to allow installation of other attachments or the standard crop dividers.
DANGER
To prevent bodily injury or death from the unexpected start-up or fall of a raised machine, always stop the engine and
remove the key from the ignition before making adjustments to the machine. NEVER climb onto or go underneath an
unsupported header.
1.
Start the engine. For instructions, refer to the combine operator
’
s manual.
2.
Lower the reel fully.
3.
Raise the header 60
–
90 cm (2
–
3 ft.) off the ground.
4.
Shut down the engine, and remove the key from the ignition.
5.
Open the endshield.