MAC215990
230
Revision A
1036115
A
B
Figure 3.311: Left Transport Wheel Pivot Pin in
Highest Storage Position
10. Ensure that pin (A) is visible at the highest storage position
in plate (B).
Moving Rear (Right) Wheels into Field Position
This procedure demonstrates how to move the wheels to the highest storage position, but you may want to use a lower
position, depending on whether or not you want the wheels to support the header during field operations.
DANGER
To prevent bodily injury or death from the unexpected start-up or fall of a raised machine, always stop the engine,
remove the key, and engage the safety props before going under the header for any reason.
1.
Start the engine.
2.
Raise the header until the transport wheels are 51
–
102 mm (2
–
4 in.) off the ground.
NOTE:
Raise the header high enough that the cylinder safety props can be engaged
—
you will need to work under the
header to complete this procedure.
NOTE:
If engaging the safety props requires raising the header to a height where it is inconvenient to work on, use blocks
to support the header so that the transport wheels are 51
–
102 mm (2
–
4 in.) off the ground.
3.
Shut down the engine, and remove the key from the ignition.
4.
Engage the header safety props. For instructions, refer to the combine operator
’
s manual.
