MAC215990
405
Revision A
1024523
B
A
Figure 4.305: Tine Tube Reinforcing Kit Opposite
Support
24. On each reel, there are two left-facing supports (A). Rotate
the supports until the flanges clear the channels before
moving them off bushing (B). Move the tube slightly away
from the reel if necessary.
25. Remove bushing halves (B) from the tine tubes.
Installing Bushings onto Reels
Once the old tine tube bushing halves have been removed, the new ones can be installed.
NOTE:
This procedure assumes the steps for
Removing Bushings from Reels, page 400
have been completed.
DANGER
To prevent bodily injury or death from the unexpected start-up of the machine, always stop the engine and remove the
key from the ignition before making adjustments to the machine.
WARNING
To prevent bodily injury from the fall of a raised reel, always engage the reel safety props before going under the
raised reel for any reason.
IMPORTANT:
Ensure the tine tube is supported at all times to prevent damage to the tube or other components.
1009854
A
B
C
Figure 4.306: Modified Channel Lock Pliers
1.
Use a pair of modified channel lock pliers (A) to install
bushing clamps (C). Secure pliers in a vise and grind a
notch (B) into the end of each arm to fit the clamp
as shown.
