MAC215990
136
Revision A
1024041
A
B
Figure 3.146: In-Cab Side Draper Speed Control
1.
Rotate knob (A) to setting 6 as a starting point.
NOTE:
Switch (B) activates the header tilt or reel fore-aft controls.
For instructions on header tilt or reel fore-aft controls, refer
to
Adjusting Header Angle from Combine, page 133
NOTE:
For CNH combines the switch to activate the header tilt or
reel fore-aft controls is on the back of the ground speed
lever (GSL).
2.
For recommended draper settings, refer to one of the
following:
•
3.7.2 Header Settings, page 66
•
3.7.3 Optimizing Header for Straight-Combining Canola,
page 78
ϭϬϰϬϰϳϴ
A
Figure 3.147: CNH In-Cab Side Draper Speed Control
Feed Draper Speed
The feed draper moves the cut crop from the side drapers into the float module feed auger.
1032494
A
Figure 3.148: FM200 Float Module
The float module feed draper (A) is driven by a hydraulic motor
and a pump that is powered by the combine feeder house drive
through a gearbox on the float module.
The feed draper speed is determined by the combine feeder
house speed and cannot be independently adjusted.
