MAC215990
354
Revision A
ϭϬϯϴϯϳϱ
A
B
B
Figure 4.200: Feed Draper Drive Roller Bearing
10. Remove bearing housing (A).
NOTE:
If the bearing is seized on the shaft, it may be easier to
remove the drive roller assembly. For instructions, refer to
Removing Feed Draper Drive Roller, page 349
.
11. Inspect both covers (B) for damage. If they are damaged,
replace them with the parts in kit MAC347553.
Installing Feed Draper Drive Roller Bearing
The bearing is held in place with bolts and a lock collar.
ϭϬϯϴϯϳϭ
D
D
C
B
D
D
A
A
B
E
F
Figure 4.201: Feed Draper Drive Roller Bearing
1.
Install two bolts (A) into the feed deck.
2.
Install both covers (B) onto the two bolts.
IMPORTANT:
Position the covers in the order shown.
3.
Install drive roller bearing housing (C) onto the shaft.
4.
Secure the housing using two nuts (D).
5.
Install bearing lock collar (E) onto the shaft.
6.
Using a hammer and punch, tap the bearing lock in the
direction of auger rotation to lock.
7.
Tighten bearing lock set screw (F).
8.
Tension the feed draper. For instructions, refer to
