MAC215990
390
Revision A
1.
Start the engine. For instructions, refer to the combine operator
’
s manual.
2.
Park the combine on a level surface.
3.
Position the header so that the cutterbar is 254
–
356 mm (10
–
14 in.) off the ground.
1034321
A
B
Figure 4.274: Fore-Aft Position
4.
Adjust the reel fore-aft position until sensor support (B)
hides the number seven on fore-aft indicator (A).
5.
Shut down the engine, and remove the key from
the ignition.
1036576
A
A
B
C
Figure 4.275: Measurement from Finger Tip to Guard
6.
Rotate the reel by hand until a tine tube is directly above
the cutterbar.
7.
Measure and record clearance (A) from the finger tip to the
top of pointed guard (B), or short guard (C). For clearance
specifications, refer to
4.13.1 Reel-to-Cutterbar Clearance,
For measurement locations, refer to:
•
Figure
–
single reel
•
Figure
–
double reel
8.
Adjust the reel clearance, if required. For instructions, refer
to