MAC215990
408
Revision A
Center disc and tail end bushings
1004616
A
B
Figure 4.313: Cam End
13. Position bushing halves (B) on tine tube (A) with the
flangeless end adjacent to the tine tube arm, and position
the lug in each bushing half into the hole in the tine tube.
14. Slide tine tube (A) onto bushing (B). Position the tine tube
against the disc at its original location.
15. Reinstall the previously removed fingers. For instructions,
refer to:
•
Removing Plastic Fingers, page 398
•
Removing Steel Fingers, page 396
1001245
A
B
Figure 4.314: Bushing
16. Install bushing clamp (A) onto the tine tube adjacent to the
flangeless end of bushing (B).
17. Position clamp (A) on bushing (B) so the edges of the clamp
and bushing are flush when the clamp is fit into the groove
on the bushing and the lock tabs are engaged.
1009869
A
B
Figure 4.315: Installing Clamp
18. Tighten clamp (A) using modified channel lock pliers (B)
until finger pressure will
NOT
move the clamp.
IMPORTANT:
Overtightening the clamp may result in breakage.