MAC215990
440
Revision A
1031910
A
B
C
D
A
Figure 4.386: Installing Pintle Ring Adapter
6.
Insert transport connector (A) of the electrical harness
through opening (B) in the pintle ring adapter.
7.
Tie or tape pull-line (C) to the harness. Gently pull the
harness through the tow-bar with the pull line at the
transport end.
8.
Ensure that transport end (A) of the harness extends 48 cm
(18 7/8 in.) past P-clip (D).
9.
Secure the harness in the P-clip with the bolt removed in
Step
.
1031912
A
B
A
Figure 4.387: Installing Pintle Ring Adapter
10. Reinstall four nuts, four bolts, and eight flat washers (A) to
secure the pintle ring adapter to the tow-bar.
NOTE:
Ensure that hardware (A) is reinstalled with the four bolt
heads on the same side.
11. Reconnect the chain with clevis pin (B) and secure it with
the cotter pin.
1034549
A
A
B
A
Figure 4.388: Torque Sequence
12. Tighten nuts (A) in the cross pattern shown. Recheck each
nut in sequence until they are torqued to 310 Nm
(229 lbf·ft).
13. Insert the hitch pin into the pintle ring adapter. Secure the
pin with the lynch pin.
NOTE:
The pins are not shown in the illustration.
