MAC215990
346
Revision A
ϭϬϯϴϱϬϭ
B
A
Figure 4.182: Idler Roller Bearing Casting
22. Move the idler roller back to the operating position.
23. Apply medium-strength threadlocker (Loctite
®
243 or
equivalent) to the threads of hardware (A).
24. On the side of the feed deck on which the casting dropped
when the hardware was removed, reinstall hardware (A) to
secure idler roller casting (B) to the frame.
25. Repeat the previous two steps on the opposite side of the
feed deck.
26. Tighten bolt (A) to 12 Nm (106 lbf·in).
IMPORTANT:
Do
NOT
fully tighten bolt (A).
27. Adjust the draper tension. For instructions, refer to
Checking and Adjusting Feed Draper Tension, page 347
ϭϬϯϴϰϵϴ
A
A
A
B
A
B
C
D
Figure 4.183: Draper Seal
28. Position mid-filler (D) as shown. Reinstall retainer (B).
29. Secure the retainer and mid-filler with one button head
screw and washer (C) and five countersunk screws (A).
30. Repeat the previous two steps on the opposite side of the
feed deck.
1028375
A
Figure 4.184: Feed Deck Pan
31. Raise feed deck pan (A).
