MAC215990
110
Revision A
1017301
A
B
Figure 3.106: Auger Finger Hole
4.
Insert guide (B) from inside the auger and secure it with
bolts (A) and tee nuts (not shown).
IMPORTANT:
Always install a new guide when replacing a solid finger.
NOTE:
Bolts (A) come with a threadlocker patch that will wear off
if the bolts are removed. If reinstalling bolts (A), apply
medium-strength threadlocker (Loctite® 243 or equivalent)
before installation.
5.
Torque bolts (A) to 9 Nm (80 lbf
∙
in).
1033130
A
B
C
D
Figure 3.107: Auger Finger
6.
Place auger finger (A) inside the drum. Insert one end of
auger finger (A) up through the bottom of guide (B) and
insert the other end into holder (C).
7.
Secure the finger by inserting hairpin (D) into the holder.
Make sure the round end (the S-shaped side) of the hairpin
faces the chain drive side of the auger. Make sure the
closed end of the hairpin points in the direction of auger-
forward rotation.
IMPORTANT:
Position the hairpin as described in this step to prevent the
hairpin from falling out during operation. If fingers are lost,
the header might not be able to feed crop into the combine
properly. Fingers that fall into the drum might damage the
auger
’
s internal components.
1033135
A
A
B
Figure 3.108: Auger Access Hole Cover
8.
Secure access cover (B) in place with bolts (A). Torque the
bolts to 9 Nm (80 lbf
∙
in).
NOTE:
Bolts (A) come with a threadlocker patch that will wear off
if the bolts are removed. If reinstalling bolts (A), apply
medium-strength threadlocker (Loctite® 243 or equivalent)
before installation.
