MAC215990
91
Revision A
1017317
1
2
A
A
A
A
3
B
B
Figure 3.66: Auger Configurations
–
Rear View
1 - Medium Configuration
2 - Wide Configuration
3 - Narrow Configuration
To convert to Narrow Configuration from Medium, Wide, or
Ultra Wide Configuration:
One flighting kit (MAC357234 or B7345
48
) is required. You will
need to replace any of the existing short flightings (A)
49
with
long flightings (B) and remove the extra auger fingers. A total of
18 auger fingers is recommended for this configuration.
IMPORTANT:
Extra hardware is included in these kits. Be sure to use the
correct hardware in the correct location to prevent damage and
to maximize performance.
•
For flighting replacement instructions, refer to
and
.
•
For finger removal instructions, refer to
1034027
A
A
Figure 3.67: Ultra Wide Configuration
NOTE:
If converting from Ultra Wide Configuration, there is no existing
bolt-on flighting to remove because that configuration uses only
the factory-welded flighting (A).
48. MAC357234 is available only through MacDon Parts. B7345 is available only through MacDon Whole Goods. Both kits
contain wear-resistant flightings.
49. The quantity of existing short flightings is either 0, 2, or 4, depending on the current configuration.
