MAC215990
347
Revision A
1028377
A
B
B
Figure 4.185: Underside of Feed Deck Pan
32. Engage lock handle (A) in three feed deck pan hooks (B).
1028380
A
B
C
Figure 4.186: Underside of Feed Deck Pan
33. Rotate handles (A) upward to bring the feed deck pan into
the locked position.
NOTE:
Ensure that all three deck pan hooks (B) are secured on the
lock handle.
34. Hold the feed deck pan in place and rotate latch (C) to lock
handle (A).
4.10.2
Checking and Adjusting Feed Draper Tension
In order for the draper to operate correctly, it must be tensioned properly. The tension on the draper will need to be
inspected and, if necessary, adjusted.
DANGER
To prevent bodily injury or death from the unexpected start-up or fall of a raised machine, always stop the engine and
remove the key before leaving the operator
’
s seat, and always engage the safety props before going under the
machine for any reason.
NOTE:
The illustrations in this procedure show the left side of the header; the right side is similar.
1.
Raise the header fully.
2.
Shut down the engine, and remove the key from the ignition.
3.
Engage the header safety props.
Checking feed draper tension
4.
Ensure that the draper guide (the rubber track on the underside of the draper) is properly engaged in the groove on
the drive roller and the idler roller is between the guides.
