MAC215990
360
Revision A
1012873
A
B
Figure 4.216: Draper Connector
19. Close the feed draper and secure it with connector
straps (B), screws (A), and nuts.
20. Tension the feed draper. For instructions, refer to
Checking and Adjusting Feed Draper Tension, page 347
Replacing Feed Draper Idler Roller Bearing
The feed draper idler roller bearing helps the roller turn. The bearing needs to be removed when replacing it.
NOTE:
Procedure is the same for both sides. Left side is shown.
DANGER
To prevent bodily injury or death from the unexpected start-up or fall of a raised machine, always stop the engine and
remove the key before leaving the operator
’
s seat, and always engage the safety props before going under the
machine for any reason.
1.
Raise the reel fully.
2.
Raise the header fully.
3.
Shut down the engine, and remove the key from the ignition.
4.
Engage the reel safety props. For instructions, refer to
Engaging Reel Safety Props, page 37
.
5.
Engage the header safety props. For instructions, refer to the combine operator
’
s manual.
B
1027877
A
Figure 4.217: Feed Draper Tensioner
6.
Locate the feed draper tensioner. Loosen jam nut (A). Turn
bolt (B) counterclockwise to relieve the tension on the
draper.
