MAC215990
178
Revision A
Installing Crop Divider Rods
The crop divider rods can be installed on the ends of the crop dividers to help separate bushy crop.
1.
Open the right endshield. For instructions, refer to
Opening Header Endshields, page 39
1029239
A
B
Figure 3.207: Divider Rods in Storage Location at Right
Header Endsheet
2.
Undo lynch pin (A) securing divider rods (B) to the header
endsheet. Remove the divider rods from their storage
location.
3.
Reinstall lynch pin (A).
1029244
A
B
Figure 3.208: Divider Rod on Crop Divider
4.
Position crop divider rod (A) on the tip of the crop divider
as shown. Tighten bolt (B).
5.
Repeat this procedure to install the crop divider rod on the
the opposite end of the header.
6.
Close the right endshield. For instructions, refer to
