MAC215990
403
Revision A
1001283
A
Figure 4.299: Bushing Clamp
15. Release bushing clamps (A) at the cam disc using a small
screwdriver to separate the serrations. Move the clamps off
the bushings.
1004616
A
B
Figure 4.300: Cam End
16. Slide tine tube (A) outboard to expose bushing (B).
17. Remove bushing halves (B). If required, remove the next
steel or plastic finger so the arm can slide off the bushing.
Refer to the following procedures if necessary:
•
Removing Plastic Fingers, page 398
•
Removing Steel Fingers, page 396
Tine tube reinforcing kit bushings
1009847
A
C
D
E
B
Figure 4.301: Tine Tube Support
18. Locate support (A) that requires a new bushing.
19. Remove four bolts (B) securing channel (C) to support (A).
20. Remove screw (E) and remove finger (D) if it is too close to
the support to allow access to the bushing. For instructions,
refer to
Removing Plastic Fingers, page 398
or