MAC215990
197
Revision A
NOTE:
For New Holland CR models 6.80, 6.90, 7.90, 8.90, 9.90, and 10.90, refer to
DANGER
Ensure that all bystanders have cleared the area.
1003627
Figure 3.241: New Holland Combine Display
1.
Engage the threshing mechanism and the feeder house.
2.
Select HEIGHT SENSITIVITY on the combine display.
3.
Use the + or
–
buttons to change the setting to 200.
4.
Press ENTER to save the new setting.
NOTE:
The sensitivity can be changed from 10
–
250 in increments
of 10. It is factory-set to 100.
Setting Preset Cutting Height
–
New Holland CR and CX Series
The reel and cut height setting can be stored in the combine
’
s computer as presets. These settings can be set and selected
using the combine
’
s control console.
NOTE:
Changes may have been made to the combine controls or the display since this document was published. Refer to the
combine operator
’
s manual for the most up-to-date information.
NOTE:
For New Holland CR models 6.80, 6.90, 7.90, 8.90, 9.90, and 10.90, refer to
1031919
C
A
B
D
Figure 3.242: Float Indicator
NOTE:
Indicator (A) should be at position 0 (B) with the header
254
–
356 mm (10
–
14 in.) off the ground. When the header is on
the ground, the indicator should be at position 1 (C) for low
ground pressure, and at position 4 (D) for high ground pressure.
Crop and soil conditions determine the amount of float to use.
The ideal setting is as light as possible without header bouncing
or missing crop. Operating with heavy settings prematurely
wears the cutterbar wearplates.
