MAC215990
57
Revision A
1001144
A
B
Figure 3.35: Header on Combine
DANGER
Ensure that all bystanders have cleared the area.
3.
Start the engine.
4.
Slowly drive the combine up to the float module until
feeder house saddle (A) is directly under float module top
cross member (B).
5.
Raise the feeder house slightly to lift the header. Ensure
that the feeder saddle is fully engaged in the float
module frame.
6.
Shut down the engine, and remove the key from
the ignition.
1001141
B
C
A
D
E
Figure 3.36: Feeder House Locks
7.
Lift lever (A) on the float module on the left side of the
feeder house, and push handle (B) on the combine to
engage locks (C) on both sides of the feeder house.
8.
Push down on lever (A) so the slot in the lever engages the
handle and locks the handle in place.
9.
If the lock does not fully engage pin (D) on the float module
when lever (A) and handle (B) are engaged, loosen bolts (E)
and adjust lock (C). Retighten the bolts.
