MAC215990
195
Revision A
DANGER
Ensure that all bystanders have cleared the area.
1003774
Figure 3.237: New Holland Calibration Dialog Box
1.
Select the MAXIMUM STUBBLE HEIGHT calibration dialog
box. As you proceed through the calibration process, the
display will automatically update to show the next step.
1003775
Figure 3.238: New Holland Calibration Dialog Box
2.
Move the header to the desired maximum stubble height
using the header up or down control switch on the
multifunction handle.
NOTE:
Set the header to a height which will never be attained
while harvesting. This will ensure that the harvest area
counter never stops recording harvesting data while the
auto header height control (AHHC) system is active.
3.
Press ENTER to continue. As you proceed through the
calibration process, the display will automatically update to
show the next step.
4.
Press ENTER or ESC to close the calibration screen. The
calibration is now complete.
Adjusting Header Raise Rate
–
New Holland CR and CX Series
If necessary, the header raise rate (the first speed on the HEADER HEIGHT rocker switch of the multifunctional handle) can
be adjusted.
NOTE:
Changes may have been made to the combine controls or the display since this document was published. Refer to the
combine operator
’
s manual for the most up-to-date information.
NOTE:
For New Holland CR models 6.80, 6.90, 7.90, 8.90, 9.90, and 10.90, refer to
