MAC215990
60
Revision A
1024737
A
B
Figure 3.41: Float Lock Handle
20. Disengage the float locks by pulling each float lock
handle (A) away from the float module and setting it in
unlocked position (B).
NOTE:
The illustration shows the right float lock; the left float lock
is similar.
Detaching Header from New Holland CR or CX Combine
The header will need to be physically disconnected from the combine, and the hydraulic and electrical connections
removed.
DANGER
To prevent injury or death from the unexpected start-up of the machine, always stop the engine and remove the key
from the ignition before leaving the operator
’
s seat for any reason.
1.
Choose a level area and position the header slightly above the ground.
2.
Stop the engine and remove the key from the ignition.
IMPORTANT:
If transport wheels are installed, the header may be detached in either transport or field mode. If detaching with the
wheels in field mode, set the wheels to the storage or uppermost working position, otherwise the header may tilt
forward, making reattachment difficult. For instructions, refer to
.
IMPORTANT:
If stabilizer wheels are installed, set the wheels to the storage or uppermost working position, otherwise the header
may tilt forward, making reattachment difficult. For instructions, refer to
Adjusting Stabilizer Wheels, page 116
.
