MAC215990
164
Revision A
Installing Floating Crop Dividers
Follow these instructions to properly install the floating crop dividers onto the header.
DANGER
To prevent bodily injury or death from the unexpected start-up or fall of a raised machine, always stop the engine and
remove the key from the ignition before making adjustments to the machine. NEVER climb onto or go underneath an
unsupported header.
1.
Start the engine. For instructions, refer to the combine operator
’
s manual.
2.
Lower the reel fully.
3.
Raise the header 60
–
90 cm (2
–
3 ft.) off the ground.
4.
Shut down the engine, and remove the key from the ignition.
5.
Open the endshields.
1032632
D
A
C
E
B
F
Figure 3.194: Crop Divider Installed
6.
Remove lynch pin (A) from quick latch (B).
7.
Attach multi-tool (C) (stored on the left endsheet) to hex
shaft (D) and rotate to release latch (B).
8.
If crop dividers (E) are installed, lift latch (B) off of bolt (F)
and set the crop dividers aside.
