MAC215990
349
Revision A
4.10.3
Feed Draper Drive Roller
The feed draper drive roller is hydraulically driven to rotate the feed draper and convey crop toward the feeder
house auger.
Removing Feed Draper Drive Roller
The feed draper drive roller needs to be removed when repairing or replacing it.
DANGER
To prevent bodily injury or death from the unexpected start-up or fall of a raised machine, always stop the engine and
remove the key before leaving the operator
’
s seat, and always engage the safety props before going under the
machine for any reason.
1.
Start the engine. For instructions, refer to the combine operator
’
s manual.
2.
Raise the reel fully.
3.
Raise the header fully.
4.
Shut down the engine, and remove the key from the ignition.
5.
Engage the reel safety props. For instructions, refer to
Engaging Reel Safety Props, page 37
.
6.
Engage the header safety props. For instructions, refer to the combine operator
’
s manual.
B
1027877
A
Figure 4.189: Feed Draper Tensioner
7.
Locate the feed draper tensioner. Loosen jam nut (A). Turn
bolt (B) counterclockwise to relieve the tension on the
draper.
1012873
A
B
Figure 4.190: Draper Connector
8.
Remove nuts and screws (A). Remove draper connector
straps (B).
9.
Lift the sides of the draper to expose the rollers.
